Dickson WiZARD2 Replaceable Sensor Logger User Guide

Dickson WiZARD2 Replaceable Sensor Logger

מפרטים

הודעה חשובה
Please follow the steps below before using your chart recorder for the first time.

Set Chart

1. לחץ על MENU פעמיים.
2. Use UP or DOWN buttons to scroll through available chart number options (chart options determined by attached sensor).
3. לחץ על MENU כדי לשמור.
4. Default Unit of Measure will display. Use UP or DOWN buttons to scroll and select alternate (option may not display depending on chart selected).
5. לחץ על MENU כדי לשמור.

הגדר זמן

1. לחץ על MENU.
2. ADJ TIME will display. Press and hold UP or DOWN button to rotate chart to the correct time or day/time as referenced by the timing arrow (just below the pen ramp).
3. לחץ על MENU כדי לשמור.
4. Press HOME. Pens will move onto the chart to begin recording.

מִבצָע

כדי להתחיל את הפעולה

1. הסר את מכסה המגן של העט.
2. Plug the Replaceable Sensor™ firmly into the logger (lower left side of case). Confirm the raised bump on the Replaceable Sensor touches the inside edge of the sensor compartment.
3. Insert Batteries (4 C type) and plug into AC adapter.
4. Install chart. Confirm the chart is aligned on the hub and slid underneath the pen home ramp and chart clip.
5. Press the power button and follow the display prompts to configure. פֶּתֶק: Unit may power on automatically when AC and battery power are applied.

שאלות נפוצות

What should I do if the unit does not power on?\

Ensure that both the AC adapter is plugged in and the batteries are correctly installed.