מָבוֹא
The Westek TMSW15MI is a hardwire indoor in-wall mechanical countdown timer designed to automatically turn off lights and motors after a selected time, up to 15 minutes. This device replaces a standard single-pole, single-throw wall switch, providing convenient timed control for various electrical loads.

תמונה: חזית view of the Westek TMSW15MI In-Wall Mechanical Countdown Timer, showing the ivory finish and the twist knob for setting the countdown time.
מידע בטיחות
WARNING: RISK OF ELECTRIC SHOCK. Improper installation can result in serious injury or death. Always consult a qualified electrician if you are unsure about any part of the installation process.
- כבה את הכוח at the circuit breaker or fuse box before installing or servicing the timer.
- Verify that power is off before proceeding with installation.
- This timer is for שימוש פנימי בלבד.
- Do not exceed the maximum electrical ratings of the device.
- ודא שכל חיבורי החוטים מאובטחים ומבודדים כראוי.
- יש להתקין מכשיר זה בהתאם לכל התקנים החשמליים הלאומיים והמקומיים.
תוכן החבילה
- 1 x Westek TMSW15MI In-Wall Mechanical Countdown Timer
- ברגי הרכבה
- Wire Nuts (typically included, but may vary)
- גיליון הוראות
מפרטים
| דֶגֶם | TMSW15MI |
| מצב פעולה | אוֹטוֹמָטִי |
| סוג מתג | Mechanical Countdown (Push Button Actuator) |
| זמן ספירה לאחור | עד 15 דקות |
| סוג מעגל | Single-pole / Single-throw (1-way) |
| סוג הרכבה | Wall Mount (replaces single gang switch) |
| סוג מחבר | מסופי בורג |
| חוֹמֶר | מתכת (רכיבים פנימיים), פלסטיק (מארז) |
| צֶבַע | שֶׁנהָב |
| מידות (L x W x H) | 6.2 x 2.9 x 2.1 אינץ' |
| דירוגי חשמל | 1 HP 125 VAC, 2HP 250 VAC, 20 Amp 125 VAC, 10 Amp 277 VAC, 5 Amp 125 VAC Tungsten |
| דירוג הגנה בינלאומי | IP00 |
הַתקָנָה
Replacing an Existing Wall Switch
- כבה את החשמל: Locate the circuit breaker or fuse that controls the switch you are replacing and turn it OFF. Verify the power is off by attempting to operate the switch or using a voltagבודק e.
- Remove wall plate: Unscrew and remove the existing wall plate.
- הסר את המתג הישן: Unscrew the old switch from the electrical box and carefully pull it out.
- ניתוק חוטים: Note the wiring configuration of the old switch. Typically, there will be two load/line wires connected to the switch and a ground wire. Disconnect these wires.
- Connect new timer: The Westek TMSW15MI timer has screw terminals. Connect the two load/line wires from the electrical box to the two terminals on the timer. If a ground wire is present in the box, connect it to the green ground screw on the timer (if available) or to the box's ground. Ensure all connections are tight and secure.
- Mount timer: Carefully push the wired timer back into the electrical box. Secure it with the provided mounting screws.
- התקנת לוחית קיר: Attach the new or existing wall plate over the timer.
- שחזור חשמל: הפעל מחדש את החשמל במפסק החשמל או בתיבת הנתיכים.
חָשׁוּב: This timer is designed for single-pole applications only. Do not attempt to install it in a 3-way or 4-way switch configuration unless you are certain of the wiring and have consulted a qualified electrician.
הוראות הפעלה
The Westek TMSW15MI mechanical countdown timer is simple to operate:
- כדי להפעיל את הטיימר: Rotate the knob clockwise to the desired countdown time (up to 15 minutes).
- The connected device (light, motor, etc.) will turn ON immediately.
- הטיימר יתחיל לספור לאחור.
- Once the set time has elapsed, the timer will automatically turn OFF the connected device by breaking the electrical circuit.
- To turn the device ON again, simply rotate the knob to the desired time.
תַחזוּקָה
- ניקוי: To clean the timer, wipe the surface with a soft, damp מטלית. אין להשתמש בחומרי ניקוי שוחקים או ממסים. יש לוודא שהחשמל כבוי לפני הניקוי.
- אין חלקים הניתנים לתיקון על ידי המשתמש: The internal mechanism of the timer contains no user-serviceable parts. Do not attempt to open or repair the unit.
פתרון בעיות
- Timer does not turn ON:
- בדוק אם מפסק החשמל פועל.
- ודא שכל חיבורי החוטים מאובטחים.
- Verify the load is within the timer's electrical ratings.
- Timer does not turn OFF:
- Ensure the knob is set to a specific time and not stuck.
- The internal mechanism may be faulty. If so, the unit may need replacement.
- Timer makes a ticking sound:
- This is normal for mechanical timers as the internal gears operate.
אַחֲרָיוּת
This Westek product is covered by a אחריות מוגבלת ל-1 שנים from the date of purchase. This warranty covers defects in materials and workmanship under normal use. It does not cover damage resulting from misuse, abuse, improper installation, or unauthorized repairs. For warranty service, please retain your proof of purchase and contact Westek customer support.
תמיכת לקוחות
For further assistance, technical support, or warranty inquiries, please visit the official Westek website or contact their customer service department. Refer to the packaging or the Westek webאתר לקבלת פרטי הקשר העדכניים ביותר.
Westek Official Webאֲתַר: Visit the Westek Store on Amazon